Brand-trained on Rinnai, Navien, Rheem, Noritz & Takagi. Accurate diagnostics and first-visit fixes.
Click Here to Call (888) 466-2103Tankless water heaters are a different category of equipment than the tank-style heaters most plumbers learned on. They use different combustion logic, different flow dynamics, different electronics, and different diagnostic protocols.
A plumber whose primary experience is tank heaters can sometimes muddle through a tankless service call. They can also misdiagnose the issue, replace the wrong component, leave the underlying problem unaddressed, and bill the homeowner for work that didn't solve anything.
The technicians at CNR Plumbing Services who handle tankless work are specifically trained on these units. This page walks through what we actually do on tankless service calls in Alamo Heights and what makes the service different from generic water heater work.
Diagnostic sequence starts with error codes and history, then tests gas supply, ignition, flame rod, flow sensors, venting, and heat exchanger output.
Full error history retrieval and brand-specific diagnostics. Common parts stocked on our trucks for same-visit repairs.
Diagnostics, recirculation pump service, descaling, and logic reconfiguration for optimal performance.
Professional descaling with isolation valves. We install valves if missing for future service efficiency.
Annual maintenance including descaling, filter cleaning, venting inspection, gas pressure checks, and combustion analysis.
When repair isn't the best option, we provide honest recommendations based on age, demand, and compatibility.
Pre-visit preparation: Confirm make, model, and age to stage correct parts.
Error code and history retrieval.
Subsystem testing: Gas pressure, flow sensors, venting, ignition, heat exchanger output.
Scope confirmation and quote.
Repair completion & verification cycle.
Documentation: What was found, replaced, and recommended next steps.
Common patterns we correct: misdiagnosing scaling as needing full replacement, incorrect recirculation settings on Navien units, replacing flame rods without fixing gas pressure on Rinnai, applying tank-style maintenance schedules, and misidentifying flow sensor issues as control board failures.
A properly maintained tankless unit in Alamo Heights should last 20 years or more. Units that get no maintenance often fail in 8 to 12 years.
We give you the actual numbers on both options. Repair under 40% of replacement cost on units under 10 years is usually worth doing.
Each code points to a specific fault. Error history is more useful than a single code.
Annual descaling is standard for most Alamo Heights homes. Hard water areas may need every 6-9 months.
Yes. Rinnai, Navien, Rheem, Noritz, Bosch, Takagi and most major brands.
We handle warranty parts process while completing the service and explain what is covered.
Stop using and call now: Visible leaking, gas smell, ignition failures with booms, visible steam.
Schedule service soon: Repeating error codes, reduced hot water output, rapid cycling.
Monitor and book maintenance: Slightly longer waits, modest gas increase, occasional self-clearing codes.
Tankless water heater acting up in Alamo Heights? Get clarity before committing to anything. CNR Plumbing Services brings brand-specific expertise.
Click Here to Call (888) 466-2103